Holmes HFH111, HFH111T, HFH110, WF110 - Compact Heaters Fan Manual

TECHNICAL SPECIFICATIONS

• Wattage: 1500W (+5% -15%)
• Working voltage: 120V AC/60Hz

AUTO SAFETY SHUT-OFF WITH CERAMIC CONTROL

This heater is equipped with a patented, technologically advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. For specific reset instructions please refer to the unit.

Tip-over Shut-off (for HFH111T only):
When the unit is accidentally knocked over, it will shut off. To reset, simply place the heater in an upright position on a level surface.

To Reset the Heater (for HFH110 and WF110 only):

1. Turn MODE to OFF.
2. Unplug unit, wait 10 minutes.
3. Plug in again and turn ON.

To Reset the Heater (for HFH111 and HFH111T only):

If the unit shuts down:

1. Turn MODE to OFF and THERMOSTAT to HI.
2. Unplug unit, wait 10 minutes.
3. Plug in and turn ON.

PRE-OPERATING INSTRUCTIONS

1. Carefully remove your heater from the box. Please save the carton for off-season storage.
2. Make sure the unit is in the OFF position before plugging the heater into the outlet.
3. Place heater on firm level surface.
4. Avoid overloading your circuit by not using other high wattage appliances in the same outlet.

OPERATING INSTRUCTIONS

1. Turn the Selector Control to desired heat setting LO orHI.
2. For fan-only operation, without any heat output, turnthe Selector Control to the FAN setting.
3. The Power Light will remain lit during operation.

SETTING THE THERMOSTAT (FOR HFH111 AND HFH111T ONLY)

1. You need to set thermostat on HI to start heater (See fig. 1). Allow heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached, lower the thermostat setting until the fan/heater stops operating.
3. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF.

Figure 1:

Figure 2:

NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.

CLEANING/MAINTENANCE

• Always unplug the heater before cleaning.
• Lightly run a vacuum cleaner nozzle over the heater grill to remove any dust or dirt that may have accumulated.
• Carefully wipe the heater with a soft, damp cloth. Please be very cautious near the motor and heating elements.
• NEVER use abrasive or flammable solvents to clean the heater.
• After cleaning, be sure to completely dry the heater with a cloth or towel.
• Store your heater in its original carton in a cool, dry location.

TROUBLESHOOTING

If your heater fails to operate, unplug the heater and:

• Make sure the electrical outlet and circuit breaker are working.
• Check for obstructions. If you find an obstruction, turn OFF and UNPLUG the heater. Carefully remove the obstruction and follow the reset instructions.
• Check the thermostat setting; it might be set too low. Turn the thermostat dial clockwise until the heater restarts.
• Make sure the Mode Control is in Lo or Hi setting.

Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions or call our Consumer Services Department at 1-800-5HOLMES.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Holmes HFH111, HFH111T, HFH110, WF110 - Compact Heaters Fan Manual