Windshield Washer Fluid - GMC Chevrolet Tahoe 2003 Manual

How to Check Power Steering Fluid
Turn the key off, let the engine compartment cool down,
wipe the cap and the top of the reservoir clean, then
unscrew the cap and wipe the dipstick with a clean rag.
Replace the cap and completely tighten it. Then remove
the cap again and look at the fluid level on the dipstick.
The level should be at the FULL COLD mark.
If necessary, add only enough fluid to bring the level up
to the mark.
What to Use
To determine what kind of fluid to use, see Part D:
Recommended Fluids and Lubricants on page 6-18 .
Always use the proper fluid. Failure to use the proper
fluid can cause leaks and damage hoses and seals.

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure to read
the manufacturer's instructions before use. If you will
be operating your vehicle in an area where the
temperature may fall below freezing, use a fluid that has
sufficient protection against freezing. See Engine
Compartment Overview on page 5-14 for reservoir
location.
5-44
Adding Washer Fluid
Notice:
•
When using concentrated washer fluid, follow
the manufacturer's instructions for adding
water.
•
Don't mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts
of the washer system. Also, water doesn't
clean as well as washer fluid.
•
Fill your washer fluid tank only three-quarters
full when it's very cold. This allows for
expansion if freezing occurs, which could
damage the tank if it is completely full.
•
Don't use engine coolant (antifreeze) in your
windshield washer. It can damage your
washer system and paint.
Open the cap with the
washer symbol on it. Add
washer fluid until the
tank is full.