Gigabyte GA-Z87X-UD5H User Manual page 27

6) CPU_OPT (Water Cooling CPU Fan Header)
The fan header is 4-pin and possesses a foolproof insertion design. When connecting a fan cable, be sure
to connect it in the correct orientation (the black connector wire is the ground wire). The speed control
function requires the use of a fan with fan speed control design.
• Be sure to connect fan cables to the fan headers to prevent your CPU from overheating. Over-
• These fan headers are not configuration jumper blocks. Do not place a jumper cap on the headers.
7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel Z87
RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instruc-
tions on configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does
• A RAID 10 configuration requires four hard drives.
DEBUG
PORT
heating may result in damage to the CPU may hang.
SATA3
7
7
are to be used, the total number of hard drives must be an even number.
not have to be an even number.)
1
5 3 1
4 2 0
- 27 -
Pin No. Definition
1 GND
2 +12V /Speed Control
3 Sense
4 VCC
Z87 Chipset)
®
Chipset supports
®
Pin No. Definition
1 GND
1
2 TXP
1
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Hardware Installation