Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket
Downrod
2 of 3
Upper Switch
bag
Housing Screw
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Fan style may vary.
Hanging Fan
Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the three light kit screws found in
the
hardware bag.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Press the globe and globe
keeper flush against the metal
plate. Thread the light pull chain
through the hole in the center of
the finial cap and thread the fan
pull chain through the hole in the
side of the cap. Finally, thread
only the light pull chain through
the hole in the finial and screw
the finial onto the threaded rod.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 3
Upper Switch
Housing Screw
3 of 3
Light Kit Screw
ON
8
Glass/Bulbs
Advertisement
Table of Contents
