Singer 14SH644 Operator's Manual page 14

• Thread the top cover thread
guide by pulling the thread
downward until it slips
under thread guide 2 .
• While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3 .
• Thread the looper area of the machine following the
orange color coded thread guides ( 4 ~ 7 ).
• Thread the hole in the upper looper from front to
back 8 .
Note: Use of tweezers provided in the accessory
set to aid in threading the looper.
• Pull about 10cm (4 inches) of thread through the
looper and place to the back of the throat plate.
2
3
8
7
6
4
5
13