Volvo V60 CROSS COUNTRY Owner's Manual page 454

STARTING AND DRIVING
||
4. Locate the "training" button
receiver for the e.g. garage door opener. It
is usually located near the antenna bracket
on the receiver.
5. Press and release the "training" button
once. Programming must be completed
within 30 seconds after pressing the but-
ton.
6. Press and release the HomeLink
to be programmed. Repeat the press/
hold/release sequence a second time. For
some receivers, the sequence may need to
be repeated a third time.
> Programming is now completed and
the garage door, gate, etc. should now
be activated when the programmed
button is pressed.
If you experience any difficulties programming,
®
please contact HomeLink
or call 1–800–355–3515.
28 The name and color of the button varies depending on the manufacturer.
452
Programming individual buttons
To program an individual HomeLink
1. Press and hold the desired button for
about 20 seconds.
2. When the indicator light on HomeLink
starts flashing slowly, it is possible to pro-
gram as usual.
Note: If the button you are reprogram-
ming does not program with a new
28
on the
device, it will return to the previously
saved programming.
Resetting the HomeLink
It is only possible to reset all HomeLink
tons at once. It is not possible to reset individ-
ual buttons. Individual buttons can only be
reprogrammed.
®
button
Press and hold the outer buttons (1 and 3)
–
on HomeLink
> When the indicator light goes from a
Related information
• Using HomeLink
• HomeLink
at: homelink.com,
• Type approval for HomeLink
®
button:
®
buttons
®
for about 10 seconds.
steady glow to flashing, the buttons
have been reset and are ready for
reprogramming.
®
* (p. 452)
®
* (p. 450)
®
* (p. 453)
Using HomeLink
®
Once HomeLink is programmed, it can be
used instead of the separate remote controls.
Press and hold the programming button. The
garage door, gate, alarm system, etc. will be
®
activated (this may take several seconds). If
the button is held down for more than 20 sec-
onds, reprogramming will begin. The indicator
light will glow steadily or flash when the but-
ton has been pressed. The original remote
controls may be used concurrently with
®
HomeLink if desired.
NOTE
®
but-
When the ignition is switched off,
®
HomeLink will be active for at least
7 minutes.
NOTE
®
HomeLink cannot be used if the vehicle is
locked and the alarm is armed* from the
outside.
®
29
*
* Option/accessory.