Discussion Device; Configure Discussion Device; Initialize Discussion Device - Bosch F.01U.299.030 Operation Manual

36 en | Configuration
7.3

Discussion Device

This section describes how to configure the device.
7.3.1

Configure Discussion Device

6 2
Figure 7.3: Exchanging the buttons
The Discussion Device is delivered as a participant's device. To configure the device as a
chairperson's device:
1.
2.
3.
4.
5.
A total of 25 Discussion Devices can be configured as chairperson's devices/interruption
microphones.
For example: 22 chairperson's devices + 3 interruption microphones = 25 devices in total.
7.3.2

Initialize Discussion Device

When a Discussion Device is powered on for the first time, it has no address and no
association with the Control Unit. To indicate this:
–
–
To initialize/address a Discussion Device:
1.
2.
3.
2020.05 | V2.2 |
6 1
6 2
6 3 6 4
Unplug the device from the system cabling.
Use the exchange tool (1) to push the single microphone button (2) from the device as
shown (store the single button in a safe place).
Preposition and then gently press the chairperson's priority button (3) and microphone
button (4) into place. Do not use excessive force!
Set the slide‑switch (2) at the base of the device from the participant's setting (0)' to the
chairperson's setting (1)'. See figure in Erase address, page 37 .
Reconnect the device to the system cabling. A restart of the system is not necessary.
the light-ring in the head of the microphone is lit red.
the LED indicator above the microphone button is lit amber.
Push the microphone button once.
Wait until all LEDs on the device are off. The device is then correctly initialized.
If the device does not initialize correctly, erase the address as described in Erase
address, page 37 , and then push the microphone button to initialize/address the device
Operation manual
Digital Discussion System
Bosch Security B.V.