Table of Contents
Advertisement
A
SETTING A PROGRAMME
1. Turn the programme knob to switch the
appliance on and set the programme:
The indicator of the button Start/Pause flashes.
2. If necessary, change the temperature and the
spin speed or add available options.
When you activate an option, the indicator of the
set option comes on.
If you set something incorrect, the
indicator of button Start/Pause flashes
red.
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button Start/Pause.
The corresponding indicator stops to flash.
The phase indicator
The programme starts and the door locks.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
1. Press the button Delay Start repeatedly to set
the required delay.
The indicator of the set delay comes on.
2. Press the button Start/Pause:
•
The door is locked.
•
The appliance starts the countdown.
•
When the countdown is completed, the
programme starts automatically.
You can cancel or change the delay
setting before you press the button
Start/Pause. After pressing the button
Start/Pause, you can only cancel the
delay.
To cancel the delay start:
a. Press the button Start/Pause to set the
appliance to pause.
When the flap is in posi-
tion B and you want to
use powder detergent:
1. Remove the drawer.
2. Adjust the flap in po-
sition A.
3. Put back the drawer
in the recess.
illuminates and stays on.
The corresponding indicator flashes.
b. Press the button Delay Start once; the
indicator of the set delay goes off.
Press the button Start/Pause again to start
the programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press the button Start/Pause.
The indicator flashes.
2. Change the options.
3. Press the button Start/Pause again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
While a programme or the delay start operates, the
appliance door is locked.
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
To open the door during the first minutes of the
cycle or when the delay start operates:
1. Press the button Start/Pause to pause the
appliance.
2. Wait some minutes until the door unlocks.
3. You can open the door.
4. Close the door and touch the button Start/
Pause again. The programme (or the delay)
continues.
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The indicator of the button Start/Pause goes off.
After a couple of minutes the phase indicator
illuminates and stays on.
to
11
Advertisement
Table of Contents
