Description Of The Washer-Dryer; Control Panel; Display - Hotpoint RD 1176 J Instructions For Use Manual

Table of Contents

Advertisement

Description of the washer-dryer

Control panel

GB
Detergent dispenser drawer
Detergent dispenser drawer: used to dispense
detergents and washing additives (see "Detergents and
laundry").
Programme Key: the Programme Key inside the deter-
gent dispenser shows all the available programmes toge-
ther with a graphical guide on how to use the individual
dispenser compartments.
ON/OFF button
chine on or off. The START/PAUSE indicator light, which
flashes slowly in a green colour shows that the machine
is switched on. To switch off the washer-dryer during the
wash cycle, press and hold the button for approximately 3
seconds; if the button is pressed briefly or accidentally the
machine will not switch off. If the machine is switched off
during a wash cycle, this wash cycle will be cancelled.
WASH CYCLE SELECTOR KNOB: used to set the desired
wash cycle (see "Table of programmes and wash cycles").
FUNCTION button: press the button to select the desired
function. The corresponding indicator light on the display
will switch on.
AUTO CLEAN button: press to clean the machine's inter-
nal parts (see "Cleaning the washer-dryer").
DIRECT INJECTION button: press to select the DIRECT
INJECTION option.
MULTI RINSE button
rinse type.
SPIN button
: press to reduce or completely exclude
the spin cycle - the value is indicated on the display.
TEMPERATURE button : press to decrease the tempe-
rature: the value will be shown on the display.
DRYING button
the selected drying level or time will appear on the display.
DRY ONLY (DRYING ONLY) button
drying cycle only.
8
ON/OFF
Programme
Key
: press this briefly to switch the ma-
: press to select the desired
: press to decrease or exclude drying;
: press to run the
DRY ONLY
(DRYING ONLY)
button
button
DRYING
button
WASH
AUTO
CYCLE
CLEAN
SELECTOR
button
KNOB
TEMPERATURE
KEY LOCK button
lock, press and hold the button for approximately 2
seconds. When the display visualises "KEY LOCK ON" the
control panel is locked (apart from the ON/OFF button).
This means it is possible to prevent wash cycles from
being modified accidentally, especially where there are
children in the home. To deactivate the control panel lock,
press and hold the button for approximately 2 seconds.
DELAY button
the selected wash cycle. The delay time will be shown on
the display.
START/PAUSE button with indicator light: when the gre-
en indicator light flashes slowly, press the button to start a
wash cycle. Once the cycle has started the indicator light
will remain lit in a fixed manner. To pause the wash cycle,
press the button again; the indicator light will flash in an
orange colour. If the symbol
may be opened. To start the wash cycle from the point at
which it was interrupted, press the button again.
Standby mode
This washer-dryer, in compliance with new energy saving
regulations, is fitted with an automatic standby system
which is enabled after about 30 minutes if no activity is
detected. Press the ON-OFF button briefly and wait for the
machine to start up again.
Consumption in off-mode: 0,5 W
Consumption in Left-on: 8 W
MULTI
RINSE
FUNCTION
button
button

DISPLAY

KEY LOCK
button
DELAY
button
SPIN
button
button
: to activate the control panel
: press to set a delayed start time for
is not illuminated, the door
DIRECT
INJECTION
button
START/PAUSE
button with indicator light

Advertisement

Table of Contents
loading

Table of Contents