Warming Up Engine; Manual Start And Electric Start Models; Shifting - Yamaha FT25B Owner's Manual

again.
NOTE:
When the engine is cold, it needs to be
G
warmed up. For further information, see
page 33.
If the engine is warm and fails to start,
G
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 72.
EMU27670

Warming up engine

EMU27710
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure warning in-
dicator goes off after starting the engine.
3. Check for a steady flow of water from the
cooling water pilot hole.
ECM00210
CAUTION:
If the low oil pressure warning indicator
G
does not go off after the engine starts,
stop the engine. Otherwise serious en-
gine damage could occur. Check the oil
level and add oil if necessary. Consult
your Yamaha dealer if the cause for the
low oil pressure warning indicator can-
not be found.
A continuous flow of water from the pi-
G
lot hole shows that the water pump is
pumping water through the cooling
passages. If water is not flowing out of
the pilot hole at all times while the en-
gine is running, overheating and seri-
ous damage could occur. Stop the
engine and check whether the cooling
water inlet on the lower case or the
cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU34530

Shifting

EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
CAUTION:
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
Operation
ZMU02034
33