Installing Dc Input Power Cables - Cisco NCS 6000 Manual

Installing the Power Components

Installing DC Input Power Cables

This section describes how to connect the DC input power cables and install DC terminal block covers. The
DC terminal block cover is one piece that covers all four DC connections per tray.
The following figure shows the DC input power cabling on the rear of the power enclosure. In this example,
the cabling for the four power trays all route to the right.
Figure 17: DC Input Power Cabling
Prerequisites
•
•
•
Before installing the cabling on the power tray, ensure that the input power cables are not energized.
Note
Ensure that there is a readily accessible disconnect device incorporated in the building's installation wiring.
Note
Note The circuit breaker and fuse lockout procedures should follow the rules and regulations in the National
Electrical Code (NEC) and any local codes.
Required Tools and Equipment
• DC power cables
Installing the Exterior Cosmetics
Installing an AC or DC Power Tray
Installing an AC or DC Power Module , on page 12
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Installing DC Input Power Cables
21