Transportation, Storage And Disposal - McCulloch M125-85FH Operator's Manual

Problem
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
24
Cause
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 8 .
The blades are loose. See
One or more of the blades are unbalanced. See
21 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
17 .
The tire pressure is different on the right and left sides. See
page 21 .
The product is operated at a too high speed. See
16 .
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

Battery safety on page 8 .
To examine the blades on page 21 .
To examine the blades on page
To examine the blades on page 21 .
To get a good result on page 16 .
To get a good result on page 16 .
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission when you tow. See
engage and disengage the drive system, M125-85FH on
page 12 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If you
keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
To clean the product on page
Tire pressure on
To get a good result on page
623 - 001 - 06.03.2018
Bat-
To