Pyle PLCAP50R Manual

5 farad square hybrid super capacitor with blue digital voltage display, blueflash led, blue neon ring

Download this manual

Enlarged version

Model: PLCAP50R

Hybrid Super Capacitor

5 Farad SQUARE

With Blue Digital Voltage Display, Blue Flash LED, Blue Neon Ring

Capacitance .............................................5,000,000 micro farad

Working Voltage ........................................... 21DC

Surge Voltage ................................................ 24DC

E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C

Capacitance Tolerance------------------------ ± 10%

DETAILED FEATURES:

3 digits hi-end blue light display DC voltage meter that can measure

0.1 DCV range.

b) Reverse pole connecting PCB buzz warning function. If the capacitor is

connected incorrectly by reversing the positive and negative wires

during the installation process the PCB will issue a 45 second noise to

warn you.

Hi-end platinum plated 100% brass solid parts and chrome plated metal

cover

d) Over voltage limit and low battery voltage limit warning. When the

system voltage peeks over 17.5 DCV or LESS than 10 DCV. The

buzzer on the PCB will issue an audible noise warning.

Multiple small capacitance capacitors linked to provide the lowest

inner E.S.R. and largest moment discharge power.

Page 1 Model: PLCAP50R Hybrid Super Capacitor 5 Farad SQUARE With Blue Digital Voltage Display, Blue Flash LED, Blue Neon Ring Capacitance ...……...5,000,000 micro farad Working Voltage ...…….….. 21DC Surge Voltage ...……… 24DC E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C Capacitance Tolerance------------------------ ± 10%...
Page 2 You must first attach the mounting tabs to the capacitor before mounting it. Use the supplied hardware shown in the picture to the right. Notice the small mounting screw hole in the capacitor chassis. The capacitor must be charged before connecting the Power and Ground cables to the capacitor.
Page 3 To Charge the capacitor: 1. Make Capacitor positive terminal connections with amplifier and tighten the bolt. Do not over-tighten the bolts! Caution: Stripped terminals are not covered under the capacitor’s warranty. 2. Connect the ground cable with battery, amplifier, then refer to the attached drawing.
Page 4 To Discharge the capacitor: With battery power disconnected, place the light bulb or resistor across the capacitor’s positive and negative terminals until light goes out or for three minutes if using a resistor. ! ! ! ! " " " " One Year Warranty from the date of purchase.