Table of Contents
Advertisement
Sliding sunroof
92
Opening and closing the roller sunblind
:
Opens
Opens
;
Closes
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the corre-
X
sponding direction.
If you press the 3 switch beyond the pres-
sure point, an automatic opening/closing proc-
ess is started in the corresponding direction.
You can stop automatic operation by pressing/
pulling the switch again.
After opening the panorama roof with power
tilt/sliding panel, the roller sunblind automati-
cally closes slightly. This reduces drafts in the
vehicle interior.
Problems with the sliding sunroof
In the following section, the term "sliding sunroof" refers to the panorama roof with power tilt/
sliding panel.
G
WARNING
If you close the sliding sunroof again immediately after it has been blocked or reset, the sliding
sunroof closes with increased or maximum force. The reversing feature is then not active. Parts
of the body could be trapped in the closing area in the process. This poses an increased risk of
injury or even fatal injury.
Make sure that no parts of the body are in the closing area.
If somebody becomes trapped:
release the switch immediately, or
R
press the switch in any direction during the automatic closing process
R
The closing process is stopped.
!
If the sliding sunroof still cannot be opened or closed as a result of a malfunction, contact a
qualified specialist workshop.
Resetting the panorama roof with
power tilt/sliding panel and the roller
sunblinds
!
If the panorama roof with power tilt/sliding
panel and the roller sunblind cannot be fully
opened or closed after resetting, contact a
qualified specialist workshop.
Reset the panorama roof with power tilt/sliding
panel and the roller sunblind if the panorama
roof with power tilt/sliding panel or the roller
sunblind does not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the 3 switch repeatedly to the point of
X
resistance in the direction of arrow = until
the panorama roof with power tilt/sliding
panel is fully closed.
Keep the 3 switch pulled for an additional
X
second.
Pull the 3 switch repeatedly to the point of
X
resistance in the direction of arrow = until
the roller sunblind is fully closed.
Keep the 3 switch pulled for an additional
X
second.
Make sure that the panorama roof with power
X
tilt/sliding panel and the roller sunblind can
be fully opened and closed again.
If this is not the case, repeat the steps above.
X
Advertisement
Table of Contents
