Installing The Drives; Installing The Front Bezel And End Caps - Bosch E2800 Installation Manual

Table of Contents

Advertisement

26
en | Installation
4.3

Installing the drives

Notice!
i
To avoid damaging the hardware, never move a unit if drives are installed. Remove all drives
before moving the unit.
To install the drives:
1.
2.
3.
4.
5.
6.
7.
4.4

Installing the front bezel and end caps

A front bezel covers the front of the controller unit and the expansion unit, while left and right
end caps cover the mounting flanges on each unit.
To install the front bezel:
1.
2.
To install the end caps:
1.
2.
3.
2021.05 | V3 | DOC
Put on the ESD wristband to protect the drives from static electricity.
Release the levers on the top drive drawer. Then, slide the drawer out by using the levers.
Raise the handle on the drive to vertical.
Starting with the leftmost slot at the front, align the two raised buttons on the drive with
the notches on the drawer. Then, pressing gently on the top of the drive, rotate the drive
handle down until the drive snaps into place.
Install the remaining drives. Observe the following if you are installing fewer than 60
drives, SSD drives or drives with different capacities:
Install drives in the front four slots of each drawer (a minimum of 20 drives in each unit)
to maintain adequate airflow for cooling.
Distribute any remaining drives across the drawers. If possible, install an equal
number of each type of drive in each drawer to allow for the creation of Drawer Loss
Protected volume groups or disk pools.
Distribute any SSD drives evenly across the drawers.
Slide the drawer back in by sliding it from the center and closing both levers gently.
Attach the bezel to the front of the unit.
Position the front bezel in front of the controller unit or the expansion unit so that the
holes at each end align with the fasteners on the unit.
Snap the bezel into place.
Position the left end cap in front of the controller unit or the expansion unit so that the
holes in the end cap align with the fasteners on the left side of the unit.
Snap the end cap into place.
Repeat these steps for the right end cap.
Installation manual
DSA E-Series (E2800 60-bay)
Bosch Security Systems B.V.

Advertisement

Table of Contents
loading

Table of Contents