Dimplex PRISM 50 Owner's Manual page 12

Fireplace Installation
Figure 6
Mounting
hole
ensure that the 3-Position Switch is
set to the Off position ("O") and that
the circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
3. Lift fireplace and insert into
opening (Figure 5).
4. Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive four
mounting
the four (4) mounting holes
located in each corner of the
fireplace chassis, into wall
studs (Figure 6).
6. refer to
Installation section, for final
installation procedures.
Flush Mounted Installation
(4) supplied
screws through
Front Glass
- 200mm Deep
CAUTION: Two people may
be required for various steps of
this procedure.
1. Prepare a wall with a framed
opening of 124.5 cm wide x 47
cm high (Figure 7).
!
NOTE: The sizing has allowed
for 6.4mm around the fireplace
insert for ease of installation. this
fireplace does not require any
additional venting.
2. Choose
supplying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
Figure 7
your method of