Mitsubishi Electric Mr.Slim PKH Series Service Manual page 35

OPERATION PROCEDURE
9. REMOVING THE FAN MOTOR
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel. (See Photo 1)
(4) Remove the electrical parts box. (See Photo 8)
(5) Remove the nozzle assembly. (See Photo 7)
(6) Remove the fan motor leg fixing 3 screws.
(7) Unscrew the set screws using by alankey and remove it by
sliding the fan motor to right.
(8) Remove the 4 screws and remove the motor cover from the
fan motor leg.
10. REMOVING THE LINE FLOW FAN
(1) Remove the terminal block cover.
(2) Remove the front panel. (See Photo 1)
(3) Remove the electrical parts box. (See Photo 8)
(4) Remove the nozzle assembly. (See Photo 7)
(5) Remove the fan motor. (See Photo 9)
(6) Remove the pipe fixture with 2 screws. (See Photo 12)
(7) Remove the left / right screws of the heat exchanger and
pull the left-hand side up.
(8) Remove the 2 screws by sliding it toward you remove the
fixture (fixing bearing).
w When the fan is hard to remove, remove the fan motor first.
w When resetting the fan to the fan motor, locate and fix the
shaft after installing the fan.
11. REMOVING THE HEAT EXCHANGER
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel. (See Photo 1)
(4) Remove the electrical parts box. (See Photo 8)
(5) Remove the corner box.
(6) Remove the nozzle assembly. (See Photo 7)
(7) Remove the 2 screws and the pipe fixture.
(8) Remove the 2 screws and heat exchanger.
12. REMOVING ELECTRICAL HEATER (PKH-P35/50GALH only)
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
(3) Remove the front panel. (See Photo 1)
(4) Remove the electrical parts box. (See Photo 8)
(5) Remove the nozzle assembly. (See Photo 7)
(6) Remove the heat exchanger. (See Photo 12)
(7) Remove the 2 screws and electrical heater.
OC330C
PHOTOS & ILLUSTRATION
(Photo 9)
Set screw
(Photo 10)
Motor cover
Fan motor
(Photo 11)
Heat exchanger
Set screws
Fixture (fixing bearing)
(Photo 12)
Set screw
Pipe fixture
(Photo 13)
35
Motor cover
Fan motor
Screws
Motor leg
Heat exchanger
Set screws
Set screws
Electrical heater