Advertisement
7.
Select the group from the Product Group drop-down list.
The product group setting specifies the mysonicwall users
who can upgrade or modify the appliance.
8.
Click Register.
If You Are Following
Scenario...
B - NAT with State Sync Pair
Proceed to Section:
Additional Deployment Configuration
page 45
Configuring L2 Bridge Mode
This section provides instructions to configure the Dell
SonicWALL NSA E8510 appliance in tandem with an existing
Internet gateway device. This section is relevant to users
following deployment scenario C.
-
This section contains the following sub-sections:
•
Connection Overview
•
Configuring the Primary Bridge Interface
•
Configuring the Secondary Bridge Interface
Connection Overview
Connect the X1 port on your Dell SonicWALL NSA E8510 to the
LAN port on your existing Internet gateway device. Then
connect the X0 port on your NSA E8510 to your LAN resources.
SonicWALL NSA E-Class
Network Security Appliance
Network Resources
- page 44
- page 45
- page 45
Network Gateway
LAN
10GE
L2 Bridge Link
E8510
X0
X1
Configuring L2 Bridge Mode |
Internet or
LAN Segment 2
44
Advertisement
Chapters
