Table of Contents
Advertisement
3
1
2
5
6
9
19
21
22
13
UNIT No. display
Displays the number of the indoor unit selected.
Also displays error code of indoor and outdoor units.
14
Central control display
Displayed when the air conditioner is used under the
central control in combination with a central control
remote controller.
In case the remote controller is disabled by the central
control system,
flashes.
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP. button is
pushed, and the button operation is not accepted.
(Settings made by the remote controller vary with the
central control mode. For details, refer to the Owner's
Manual of the central control remote controller.)
17-EN
13
7
14
18
8
4
12
11
15
10
17
15
Remote controller sensor display
Displayed while the sensor of the remote controller
is used.
16
Pre-heat display
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
17
No function display
Displayed when the function requested is not available
on that model.
18
Self clean operation display
Displayed during self clean operation to dry the indoor
heat exchanger.
19
Service display
20
Operation ready display
This display appears on some models.
21
Louver Number display.
(exapmle:01, 02, 03, 04)
22
Louver lock display
Displayed when there is a louver-locked unit in the
group (including 1 indoor unit by 1 outdoor unit).
– 9 –
Operation section
Push each button to select a desired operation.
•
The control saves commands in memory and after the initial setting, there is no need for any additional
settings unless changes are desired. The air conditioner can be operated by pushing the
1
2
20
16
3
4
1
Adjusts the set point.
Select the desired set point by pushing
or g
2
Use to setup the timer.
3
button (Filter reset button)
Resets
4
button (Test button)
Use only for service.
(During normal operation, do not use this button.)
5
When the button is pushed, the operation
starts, and it stops by pushing the button again.
When the operation has stopped, the operation
lamp and all the displays disappear.
6
(Operation lamp)
Green light Green light illuminates when unit is on.
Although it flashes when operating the
protection device or an error occurs.
7
Selects desired operation mode.
8
Selects the desired Fan speed.
9
Use when a power ventilation kit (locally procured) is
connected.
If "
•
this button is pushed, no vent kit connected.
10
Use to initiate power saving mode.
11
button (Temperature set button)
TEMP.
TEMP.
button (Timer set button)
display after cleaning filter.
12
button (Test button)
OPTION :
Remote controller sensor
Usually the temperature sensor of the indoor unit
senses the temperature. The temperature on the
surrounding of the remote controller can also be
sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
button (Operation mode button)
button (Fan speed button)
button (Ventilation button)
" is displayed on the remote controller when
button (Power save operation)
button.
5
6
7
8
9
10
11
12
button (Unit / Louver select button)
Selects a unit number (left) and louver number (right)
UNIT:
Selects an indoor unit when adjusting wind direction
multiple indoor units are controlled with one remote
controller.
LOUVER:
Selects a louver when setting wind direction
adjustment independently.
button (Swing / Louver direction
button)
Selects automatic swing or setting the
louver direction.
18-EN
Advertisement
Table of Contents
