Figure 109
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10.
Fine-tune the adjustment nut on the front
deck-lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
g009196
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
110).
1. Adjustment nut
2. Jam nut
11.
To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure
111).
1. Bolts at the bottom of the height-of-cut plate
12.
If the deck is too low, tighten the
single-point-adjustment bolt by rotating it
clockwise. If the deck is too high, loosen
the single-point-adjustment bolt by rotating it
counterclockwise
70
Figure 110
3. Rear deck adjustment
4. Front deck adjustment
Figure 111
(Figure
112).
g027344
g027345