Retained Accessory Power (Rap); Shifting Into Park - Buick Encore 2022 Owner's Manual

Table of Contents

Advertisement

138
Driving and Operating
2. Open the hood and unwrap the electrical
cord. The cord is in the driver side of the
engine compartment, near the battery.
It is shipped from the factory with a tie
holding it in place. Use care in removing
the tie so that the cord is not damaged.
Check the heater cord for damage. If it is
damaged, do not use it. See your dealer
for a replacement. Inspect the cord for
damage yearly.
3. Plug it into a normal, grounded 110-volt
AC outlet.
Warning
Improper use of the heater cord or an
extension cord can damage the cord and
may result in overheating and fire.
Plug the cord into a three-prong
electrical utility receptacle that is
protected by a ground fault detection
function. An ungrounded outlet could
cause an electric shock.
Use a weatherproof, heavy-duty,
15 amp-rated extension cord if needed.
Failure to use the recommended
extension cord in good operating
condition, or using a damaged heater
Warning (Continued)
or extension cord, could make it
overheat and cause a fire, property
damage, electric shock, and injury.
Do not operate the vehicle with the
heater cord permanently attached to
the vehicle. Possible heater cord and
thermostat damage could occur.
While in use, do not let the heater
cord touch vehicle parts or sharp
edges. Never close the hood on the
heater cord.
Before starting the vehicle, unplug the
cord, reattach the cover to the plug,
and securely fasten the cord. Keep the
cord away from any moving parts.
4. Before starting the engine, be sure to
unplug and store the cord as it was
before to keep it away from moving
engine parts. If you do not it could be
damaged.
The length of time the heater should remain
plugged in depends on several factors. Ask a
dealer in the area where you will be parking
the vehicle for the best advice on this.
(Continued)

Retained Accessory Power (RAP)

When the ignition is turned from on to off,
the following features (if equipped) will
continue to function for up to 10 minutes,
or until the driver door is opened. These
features will also work when the ignition is
in RUN or ACC/ACCESSORY:
Infotainment System
Power Windows (during RAP this
functionality will be lost when any door
is opened)
Sunroof (during RAP this functionality will
be lost when any door is opened)
Auxiliary Power Outlet
Audio System
OnStar System

Shifting Into Park

1. Hold the brake pedal down and set the
parking brake. See Parking Brake 0 144.
2. Move the shift lever into P (Park) by
pressing the button on the shift lever
and pushing the lever all the way
toward the front of the vehicle.
3. Turn the ignition off.

Advertisement

Table of Contents
loading

Table of Contents