Nedis HQ-RS1101 - LED PR Sensor Light Manual

Loading Battery

1. Spin the battery cover according to the "OPEN" arrow direction and load 3xC type batteries following the polarity direction.
2. Spin the battery cover according to the "LOCK" direction.

Note: If the battery is loaded correctly, white LED will blink 3 times then stays on "OFF" mode. Please take out the battery when not in use.

Light Mode Selection

ON/OFF button

Press on/off button to choose the mode:
AUTO PIR SENOR/STEADY COOL WHITE/STEADY WARM WHITE
The product offers 3 modes for selection

Note: As the product has environment light detection, under AUTO PIR sensor mode, the light only lights up when environment light below 9 lux. (The light will not light up in day time even it detects any motion. ) There is a red LED indicator flickering while on AUTO PIR sensor mode.

Placement

You can place the light on the table, book case, shelf and ground or use the hook and hang it on the tubes or ground stick with ground insert to fix on the ground.

Installation

There are 2 sticks included. You can choose the height you desire by the stick and connector attached.

Sensor Range

The PIR sensor will detect motion when body enter to its range. The sensor range detection distance can be changed by fixing height. The sensor light will be switched off automatically when no movement is detected for 30 seconds.

T: +31 (0)73-5993965
E: service@nedis.com
W:http://www.nedis.com/en-us/contact/contact-form.htm

NEDIS B.V.

De Tweeling 28
5215 MC 's-Hertogenbosch
HOLLANDIA

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Nedis HQ-RS1101 - LED PR Sensor Light Manual