Emptying The Dirt Tank; Removing The Brush Roll - Bissell ICONPET 2288 Series Manual

Emptying the Dirt Tank

More of a video person? Go to BISSELL.ca/support for additional how-to videos.
1. 2.
Turn OFF your machine. Grab the top of the tank
Remove the Dirt Tank from the and pull up. This will activate a
hand vacuum by sliding the wiping feature to remove debris
latch on the front of the tank. from the mesh filter screen.
4. 5.
Dump dirt from the tank Slide the separator back
into the trash bin. into the tank, ensuring the
notch is seated into the tank
correctly.

Removing the Brush Roll

Go to BISSELL.ca/support for a full list of maintenance and troubleshooting support.
1. 2.
Turn the machine OFF and With a flathead screwdriver
press the Foot Release Button or coin, twist the slot on the
to disconnect the Motorized side of the foot clockwise and
Floor Cleaning Foot from the pull the Brush Roll out.
Extension Wand.
WARNING
» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all fi lters, both pre and post-fi lters, are in
place. DO NOT operate your vacuum without these fi lters.
8 BISSELL.ca
3.
Fully remove the separator
from the tank and tap the
mesh screen on the side of the
trash bin.
2
1
6.
Put the whole tank into
the hand vacuum by guiding
the notched out area on the
bottom of the tank onto the
hook on the hand vacuum.
Push into place.
3.
To replace, push the Brush
Roll back in the chamber and
twist counter-clockwise with a
tool or coin to lock in place.