Table of Contents
Advertisement
V Preparation for use
1.Install the battery for the remote controller
a. Press the cover of the battery compartment on the
remote controller and remove it.
b. Insert 2 batteries, make sure the polarity (+) or (-) of
batteries conforms to the polarity marks in the battery
compartment.
c. Slide the cover of the battery compartment to the
original place.
Note:
Do not drop or dismantle the remote controller.
5
Do not get it wet
If the remote will not be used for some time remove
the batteries to prevent damage.
Do not mix new and old batteries.
Properly recycle used batteries.
Be familiar with the name and function of the remote control buttons
Description of basic remote control buttons and key controls on the front panel:
Control button
MENU
CH+
CH-
VOL+
VOL-
TV/VIDEO
POWER
The operation status shown by the power indicator :
1.Green light-Operation status
2.Red light- Standby status
3.Flashing of green light-Energy saving status and when the screen display No Signal message
Remote Sensor
Note: When the electricity is just switched on, the unit is under Standby status.
The function during viewing
Select the screen display menu system
Select to display the next stored channel
Select to display the previous stored channel
Increase volume
Decrease volume
Switch the input signal
Switch the set to standby status.
Power Indicator
Back of the remote controller
The function when using the menu
Enter the next menu button
Select to display the previous menu item
Select to display the next menu item
The content selection for item
Increase the value of the current item
Decrease the value of the current item
The content selection for item
Exit Menu button
Switch the set to standby status
Front of the whole set
Main Power Switch
5
Advertisement
Table of Contents
