Wps-Pbc Configuration - D-Link E30 User Manual

Section 3 - Configuration

WPS-PBC Configuration

Wi-Fi Protected Setup Push-Button Configuration (WPS-PBC) makes connecting your E30 easy. To use WPS-PBC Configuration, first
make sure the main router or access point features a WPS Button or has a virtual WPS Button.
Step 1 - Initiate WPS Mode
While the Status LED is blinking orange, push the WPS button on the main wireless
router or AP, and then push the WPS button on the E30. The Status LED will start to
flash white. Please allow up to two minutes for the process to finish. The Status LED
will turn solid white when the E30 has connected successfully to the source wireless
router or access point.
Step 2 - Connecting Devices to the E30
The E30 is now ready to share the extended Wi-Fi network with your PCs and mobile
devices. You may use the WPS method to connect devices to the extended network
created by the E30 using the same network name (SSID) of the main router. The
password will also be the same as the wireless network you are extending.
The Smart Connect feature will present a single wireless network. When connecting
clients to the extended network, they will be automatically added to the best band,
either 2.4 GHz or 5 GHz. To disable the Smart Connect feature and individually
configure 2.4 GHz and 5 GHz SSIDs, refer to "Extender Settings" on page 26.
D-Link E30 User Manual 12