Ryobi P21014 Operator's Manual page 8

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Blower
Blower Tube
Speed Tip (2)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
ASSEMBLY
INSTALLING THE BLOWER TUBE
See Figure 2.
 With the tab facing down, place the blower tube on the
blower housing outlet and press together until the tab
locks onto the latch on the blower housing.
NOTE: Pull on the blower tube to be sure it is securely
installed. Once secured, the tube cannot be removed
from the blower housing until the latch is released.
NOTICE:
When correctly assembled, the tube is difficult to sepa-
rate. If it can be easily removed, the tube is not locked.
Check that the tab is fastened securely onto the latch.
If the tube is not in the locked position, it can separate
during blower operation.
 To remove the tube, raise the tab to release and remove
it from the blower housing outlet.
 To install the speed tip: Align the tab on the speed tip
with the latch on the blower tube and press together until
the tab locks into place.
 To remove the speed tip: depress the tab and slide the
speed tip off.
NOTE: When the speed tip is installed the unit can generate
air volumes of up to 450 CFM. To reduce air velocity and
increase air volume, cut the speed tip along the cut line. Cut
portions of the tube cannot be reassembled.
6 — English