Table of Contents
Advertisement
A
ssembly
1.
Locate hardware pack for handle assem-
bly. Enclosed are two nut and bolts for the
handle, as well as upper (larger) and lower
(smaller) plastic cord hooks. An extra drive
belt is also included.
2. Connect lower handle to the base of
the unit. The thinner end should point
upwards, toward the top of vacuum.
Connect upper handle to lower handle
by sliding into each other. Upper handle
should curve towards the back of the unit.
Insert nuts and bolts and tighten.
3. Thread nut and bolt through hole in upper
and lower handle. Screw together nut and
bolt by hand, then tighten with screwdriver.
4. Take lower cord hook with vacuum facing
frontwards and snap into slot on lower
handle with hook facing down.
5. Take upper cord hook and place cord with
spring retainer into slot and snap in.
6. Wrap cord around cord clips.
7. To attach the shake-out bag to the vacuum,
find hook on the bottom of the bag and
hook it to the back of the vacuum base.
(See image) Align latch with the back of the
vacuum and bring the collar forward. Turn
latch so that bag locks onto rivet.
8. Attach spring from top of the shake-out bag
to the bag clip on upper cord wrap.
w w w . b i s s e l l c o m m e r c i a l . c o m
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition.
1.
4.
7a.
1 - 8 5 5 - 5 4 4 - 7 3 3 6
6
7b.
5
Advertisement
Table of Contents
