Brother BAS-311H Basic Operation Manual page 23

Operator
Green and yellow wire
(ground wire)
BAS-311H
<200 V system >
(1) Power switch
(2) Screws [2 pcs]
3146B
(3) 3-pin power supply connector
3147B
(4) Power cord
(5) Staples [5 pcs]
1. Attach an appropriate plug to the
power cord (4). (The green and yellow
wire is the ground wire.)
2. Insert the
properly-grounded electrical outlet.
NOTE:
• Take care when tapping in the staples
(5) to make sure that they do not pierce
the cords.
• Do not use extension cords, otherwise
machine operation
result.
3. Use the six screws to tighten the cover
of the control box. Check that none of
the cords are being clamped by the
cover at this time.
3. INSTALLATION
power plug into a
problems may
15