Advertisement
Quick Links
TM
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
WARNING: Make certain power is OFF before starting installation or attempting any maintenance.
Thru-way Mounting Kit*
1. The thru-way mounting kit is intended for use when a conduit
run is surface mounted to a wall. It is designed to be used
with 3/4-14 NPSL threaded conduit.
2. Install anchors (supplied by others) for 1/4" screws in the wall
using hole pattern as shown (See Fig.1).
3. Install 1/4" teflon washers on mounting screw (supplied by
others) and mount the thru-way box as shown (See Fig. 2).
4. Remove gasket backing and install as shown.
5. Start two (2) 1/4-20 x 2.00 hex head cap screws, leaving
approximately 1-3/8" under the head of the screws.
3/4 - 14 NPSL
Conduit Run
1.19
*For Downward Mounting Only.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user's purpose, please
contact your nearest representative.
9.56
1/4" Wall Anchor Screws (By Others)
1/4" Teflon Washer (2) Supplied
1/4 20 x 200 Hex HD Screws (2)
(Fixture Mounting)
2.38
Gasket (1) Supplied
Shipped Loose
Fig. 2
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269
VISION WALL
VWS/TB
2/17/04
4.00
2.31
2.38
7.59
Fig. 1
IMI-435
Wall Mounting
Holes
CL Conduit
IMI-435 AVU040292
Advertisement
