Using WebBrowser
Enabling JavaScript
If JavaScript has been set to disable, enable it.
Open <Internet Properties> window.
1
Click [Start] → [Control Panel] → [Network and Internet Connections] → [Internet Option].
Select [Security] and set the security level to [Default Level], or select [Custom
2
Level] and check the [Enable] checkbox under [Active scripting].
Accessing from the WebBrowser
1
Click [
] on the launcher.
Or start up the WebBrowser, and enter the IP address set by the projector.
The WebBrowser starts up and the authentication window appears.
<Top window>
2
Enter the user name and the password.
3
Click [OK].
<Monitored information> window appears. (Next page)
• The default user name and password settings are as follows.
User name: user1
Password: (The password is not set.)
• Password used in this page is for accessing the web control window. (See page 66)
This password is different from the password set in page 56 for accessing a projector.
• If you forget the password, perform [INITIALIZE] using the network menu of the projector (See page 58) and set a password
again using the <Change password> window on the WebBrowser. (See page 66)
• The top window may not appear depending on the WebBrowser. In this case start up WebBrowser again, or press the [Ctrl] +
[R] keys for example to update the screen.
• Connection cannot be made while the WebBrowser is set to dial-up network. Cancel the dial-up network setting.
• It may take some moments for WebBrowser to start up.
(cont.)
60