Section 8
Removing, repairing and exchanging
IEC17000158 V1 EN-US
Figure 16: IED summary
8.3
Removing the IED
Before removing the IED, make sure that auxiliary power is turned off and all wiring is
disconnected.
8.4
Sending the IED for repair
In case of product problems, contact the nearest ABB office or representative for consultation
and instructions.
8.5
Exchanging the IED
To exchange the IED with another identical unit, remove the IED and install the new one.
Contact your local ABB for information about exchangeable units.
36
For upgrade purposes the IED does not need to be removed. Before removing
the IED check with your local ABB office if the IED can be upgraded.
© Copyright 2017 ABB. All rights reserved
1MRK 514 030-UEN B
IEC17000158-1-en.vsdx
GUID-6F99E661-D319-4782-97E9-3A864B1E972D v2
GUID-1EB39784-696C-4B2E-B560-4115F721DCAB v9
Switchgear control unit SAM600-IO
Installation manual
AMU0600445 v4