Table of Contents
Advertisement
2. The supply system is equipped with
an efficient earth connection in
compliance with the current standards
and regulations
3. The outlet or omnipolar switch used
for connection is easily accessible with
the appliance installed.
The appliance is supplied with a 3 core
flexible power cable with a 3 amp plug. If it
is necessary to change the fuse, use a 3
amp ASTA-approved (BS 1362) fuse.
A
E
A. Green and Yellow
B. 3 amp fuse
C. Brown
D. Cord clamp
E. Blue
The wires in the cord are coloured as
follows:
Green and yellow
Blue
Brown
WARNING!
A cut off plug inserted into a
13 amp socket is a serious
shock hazard. Ensure that
the cut off plug is disposed of
safely.
B
C
D
- Earth
- Neutral
- Live
8.7 Replacement of the
connection cable
The replacement of electric
cable must be carried out
exclusively by the service
force centre or by personnel
with similar competencies, in
accordance with the current
regulations.
To replace the connection
cable use only H03V2V2-F
T90 or equivalent type. Make
sure that the cable section is
applicable to the voltage load
and the working temperature.
The yellow/green earth wire
(B) must be approximately 2
cm longer than the live and
neutral wire (A).
1. Connect the green and yellow (earth)
wire to the terminal which is marked
with the letter 'E', or the earth symbol
, or coloured green and yellow.
2. Connect the blue (neutral) wire to the
terminal which is marked with the
letter 'N' or coloured blue.
3. Connect the brown (live) wire to the
terminal which is marked with the
letter 'L'. It must always be connected
to the network phase. There must be
no cut or stray strands of wire present.
The cord clamp must be correctly
attached to the outer sheath.
ENGLISH
15
A
B
Advertisement
Table of Contents
