Dell UltraSharp 32 User Manual page 91

A message is displayed while the cable supporting DP alternate mode is connected to
the monitor under the following conditions:
• When Auto Select for Thunderbolt(140W) is set to Prompt for Multiple
Inputs.
• When the Thunderbolt
If two or more ports are connected, when the Auto of Input Source is selected, it will
turn to the next port with signal.
Select OSD items of On in Standby Mode in Personalize feature, the following
message will appear:
If adjust the Brightness level above the default level over 75%, the following message
will appear:
• When user selects "Yes", the power message is displayed only once.
• When user select 'No', the power warning message will pop-up again.
• The power warning message will appear again only when the user does a Factory
Reset from the OSD menu.
cable is connected to the monitor.
TM
Select the primary use of the monitor's Thunderbolt connection:
Display PC screen while charging
Only charge device
Always display PC screen while charging
Auto Thunderbolt (140W)
Changing to this setting ( without
power consumption. Do you want to continue?
Adjusting to this value will increase power consumpiton above the default level.
Do you want to continue?
mDP HDMI
symbol) will increase
Yes
No
Yes
No
Operating the monitor
Exit
| 91