Daewoo DWD-E1200R S Svc Manual page 34

4. ERROR DISPLAY
MESSAGE ERROR
The water tap is closed.
The filter of the valve inlet is clogged.
The valve inlet is an inferior product or broke down.
WATER INLET
IE The water level sensor (sensor pressure) is an inferior product or Change the water level sensor
ERROR
broke down.
The drain motor works during water supply.
The PCB ASS'Y does not check the water level.
The drain hose is kinked or clogged.
The drain motor is an inferior product.
DRAIN
OE
The valve inlet works during drain.
ERROR
The water level sensor is an inferior product .
The PCB ASS'Y does not check the water level.
The laundry is concentrated to one side of the drum
UN-BALANCE
UE
ERROR
during spin.
The Start/Hold button is pressed while the door is opened.
DOOR OPEN
LE
The switch door lock is an inferior product.
ERROR
The PCB ASS'Y does not check the door lock.
The water is supplied continuously due to an inferior valve inlet. Change the valve inlet.
The valve inlet is normal, but the water level sensor
OVERFLOW
E2 (sensor pressure) is inferior.
ERROR
The drain motor dose not work.
(The drain motor is an inferior product or broke down.)
The fan motor does not work.
(The fan motor is an inferior product or broke down.)
FAN MOTOR
E3
ERROR
The PCB ASS'Y does not control the fan motor.
Water leaks from the tub or the hose drain.
LEAKAGE
E4
ERROR
The foreign matter is jammed in the drain bellows.
(Non-pump model)
The laundry is jammed between the gasket and the drum.
HIGH VOLTAGE
E5
ERROR
The PCB ASS'Y is an inferior product.
The laundry is jammed between the gasket and the drum.
E6 EMG ERROR
The motor is an inferior product.
The PCB ASS'Y is an inferior product.
The motor spins into an opposite direction.
DIRECTION
E7
ERROR
The motor hall IC is an inferior product or broke down.
The motor is not normally connected.
E8 MOTOR ERROR The motor does not work.
(The motor is an inferior product or broke down.)
SENSOR
The water level sensor is an inferior product.
E9
PRESSURE ERROR
CAUSE
30
SOLUTION
Open the water tap.
Clean the filter of the valve inlet.
Change the valve inlet.
(sensor pressure).
Change the drain motor.
Change the PCB ASS'Y.
Clean and straighten the drain hose.
Change the drain motor.
Change the valve inlet
Change the water level sensor.
Change the PCB ASS'Y.
Rearrange the laundry.
Close the door.
Change the switch door lock.
Change the PCB ASS'Y.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the fan motor.
Check the connector or change the
PCB ASS'Y .
Check the leak of the tub or the hose drain.
Then change the tub or the hose drain.
Remove the foreign matter in the
drain bellows.
Rearrange the laundry.
Change the PCB ASS'Y.
Rearrange the laundry.
Change the motor.
Change the PCB ASS'Y.
Change the PCB ASS'Y or the motor.
Change the motor hall IC or the motor.
Check the connector of the motor.
Change the motor.
Change the water level sensor.