D-Link DCS-8526LH User Manual page 21

Section 3 - mydlink
1 Device Photo
2 Device Name
3 Device Location
4 Time Zone
5 Wi-Fi
6 Designated Contact
7 Camera Microphone
8 Motion Settings
Point to Go
9
Auto Home
10
11 Night Vision
12 Anti-Flicker
13 Pan-Tilt Control
14 Privacy Mode
15 Invert Image
16 Reverse Swipe Direction
D-Link DCS-8526LH User Manual
Tap to add a customized photo of this device.
Tap to change the device's name.
Tap to change or add a new location for this device.
Select the time zone to calibrate your device to.
Tap to change the wireless network this device will use to connect to the
Internet.
Note: The network must be the same as all your other mydlink
devices that you wish to use the same account for.
Tap here to add, remove, or edit designated contacts that appear in the
rich notification.
Tap to enable or disable picking up sound near your camera in live view
and recordings.
Tap to further configure sensitivity and the active area of motion
detection.
This photo is what you will see when you control your viewpoint in the
camera's Point to Go live-view. Tap Rescan to scan a new panorama.
Enable to automatically return your camera to the set 'Home Point'
after 60 seconds of inactivity.
Tap to change night vision detection to On, Off or Auto.
Reduces flicker in the video. Tap 50 Hz or 60 Hz depending on the frequency
of your lights.
Choose whether to control your camera's Point to Go live-view pan-tilt
control by swiping or tapping.
Tap to enable. Privacy mode will disable the camera feed.
Enable this to invert the camera view.
Tap to reverse the swipe direction.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18