Cleaning, Care And Maintenance; Cleaning The Condenser; Troubleshooting - Polar Electro GG753 Instruction Manual

EN
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues. DO
NOT wash the base unit, instead wipe the exterior with a damp cloth.
• Empty and clean the drip trays regularly.
• Unit should be de-scaled regularly. Note that scale may cause premature failure of the machine and it
could invalidate your warranty.

Cleaning the Condenser

POLAR recommend the condenser is cleaned at least once a month.
Note: The condenser is the black (CF760) or silver (CF761/GG753) metal grid
behind the side panel.
To clean the condenser:
1. Unscrew the two screws from beneath the Temperature controller side panel.
2. Lift the side panel up and over Temperature controller to remove.
3. Clean the condenser with a soft cloth or brush.
WARNING: Take care when cleaning the condenser; sharp edges may cut.
4. Replace the panel and two screws.

Troubleshooting

A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The dispenser is not
cooling
The mixing paddles are
not working
The tank is leaking
6
CF760_CF761_GG753_ML_A5_v10_20230228.indb 6 CF760_CF761_GG753_ML_A5_v10_20230228.indb 6
Probable Cause
The unit is not switched on
Plug or power cord is damaged
Fuse in the plug has blown
Mains power supply fault
Coolant leak
Fan motor failed
Airflow obstructed to the
condenser
Condenser is clogged
Mixing motor has failed
Gasket problem
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Consult a qualified technician
Consult a qualified technician
Increase the gap between appliance and
obstacles/heat source
Remove side panels and clean condenser
Consult a qualified technician
Check the gaskets and replace if necessary
2023/2/28 15:32 2023/2/28 15:32