MSI H61I-E35 V2/W8 Series User Manual page 4

FCC-B rAdIo FrEQuENCy INtErFErENCE StAtEMENt
this equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 5 of the FCC rules. these limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. this equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the measures listed below.
reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ television technician for help.
Notice 
the changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Notice 2
Shielded interface cables and A.C. power cord, if any, must be used in order to
comply with the emission limits.
VoIr LA NotICE d'NStALLAtIoN AVANt dE rACCordEr Au rESEAu.
Micro-Star International
MS-7677
this device complies with part 5 of the FCC rules. operation is subject to the
following two conditions:
() this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CE CoNForMIty
Hereby, Micro-Star International Co., Ltd declares that this de-
vice is in compliance with the essential safety requirements and
other relevant provisions set out in the European directive.
4