Page 1
Installation Guide and Users Manual Questions, problems, missing parts? Before returning to the store, call NAUXUS Customer Service 8 a.m.-6 p.m.,EST, Monday-Friday 1-(832)941-6306 1-(909)858-6868 NAUXUS.COM MODEL: IMPORTANT: NX-E90-30 Read and save these instructions. NX-E90-36 NOTICE: Installer: Leave this guide with the homeowner...
Page 3
Important Safety Notice Read all Instructions before Installing and operating this appliance • The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified background. Installation and electrical wiring must be done by qualified profession- als and in accordance with all applicable codes and standards, including fire-rated construction.
Page 4
Important Safety Notice Read all Instructions before Installing and operating this appliance • Clean ventilating fan frequently. • Always use appropriate cookware and utensils size. • Always use cookware appropriate for the size of the surface element. To reduce the risk of injury to persons in the event of a stove top grease fire: •...
Table of Contents USE AND CARE INSTALLATION Tools needed............3 Troubleshooting...........13 Parts supplied...........4 Use and care information.......14 Venting requirements........5 Specifications..........14 Mount heights & clearance......5-6 MAINTENANCE Calculating vent system length.......6 Cleaning& Replacing filter .....15 Replacing light bulb.........15-16 Venting methods&Charcoal filter Installation.7 Electrical requirements........8 Disclaimer ............17 Installation............9 Range hood operations ......10-11...
Venting Requirements Height & Clearance Vent system must terminate to the outside • (roof or side wall). Do not terminate the vent system in an attic • Cabinet or other enclosed area. Do not use 4” (10.2 cm) laundry-type wall •...
Height & Clearance (Continued) IMPORTANT: A minimum of 6” round (standard for this range hood) must be used to maintain maximum airflow efficien- • Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided • duct.
Page 9
Venting Methods This power pack range hood insert is factory set for venting through the roof or wall. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. • IMPORTANT: NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or •...
Electrical Requirements IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualified electrician for 220-Volt 50 Hz voltage) It is the customer’s responsibility: To contact a qualified electrical installer. To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/ NFPA 70 —...
(Fig. B). Note: Wood blocking might need to be built if it’s not available in order to secure the mounting screws. 4. Connect the duct and power cord. 5. Replace the decorative panel. Model NX-E90-30 28 1/8 " 16 5/8 " NX-E90-36 32 1/2 "...
Range Hood Operations Speed Electronic Touch Control Power Light Power-Off Delay Increase Value Decrease Value Power-Off Delay Digital Timer Blower Speed Indicator Cleaning Reminder Indicator This range hood is designed to remove smoke, cooking vapors and odors from the cook top area. For best results, start the range hood before cooking and allow it to operate several minutes after the cooking is completed to clear all smoke and odors from the kitchen.
Page 13
Range Hood Operations (Continued) 3 Speed Electronic Touch Control Power Light Power-Off Delay Increase Value Decrease Value Power-Off Delay Digital Timer Blower Speed Indicator Cleaning Reminder Indicator • Controls: • Adjusting the timer function: • While the blower (motor) is not running, press and hold Decrease Value button over 3 seconds to enter timer mode.
Troubleshooting 1. If the range hood does not operate after installa- Check if the range hood has been plugged in, make • tion: sure that all power has been turned back on and all electrical wiring are properly connected. Swap out light assembly to working ones to deter- •...
Use and Care Information WARNING — TO REDUCE THE RISK OF FIRE, ELEC- lowed to accumulate on fan or filter. TRIC SHOCK, OR INJURY TO PERSONS, OBSERVE Use proper pan size. Always use cookware appropriate for THE FOLLOWING: Use this unit only in the manner in- the size of the surface element.
Maintenance SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating! For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly. Regular care will help preserve the appearance of the range hood. Cleaning Exterior surfaces: Clean periodically with hot soapy water and clean cotton cloth.
Page 18
Maintenance (Continued) Replacing LED Light Fixture: This range hood uses LED light fixture: 3W Max 12V LED • Make sure the range hood is unplugged or turn OFF breaker and the lights are cool to touch. • Place a flat-head screwdriver between light housing and hood body, gently pry up the light housing and search for the •...
Disclaimer Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately.