LG LSMC3086SS Owner's Manual page 51

Problem
Spark / Arcing
Unit has no power
Vent is not working
- Weak or no ventilation
- Abnormal noise during
operation
- Product overheating
The cost of repair or replacement under the above excluded circumstances shall be borne by the
consumer.
TO OBTAIN WARRANTY SERVICE AND ADDITIONAL INFORMATION
Call 1-800-243-0000 and select the appropriate option from the menu.
Or visit our website at http://www.lg.com
Or by mail: LG Electronics Customer Service P.O. Box 240007 Huntsville, AL 35813 ATTN: CIC
PROCEDURE FOR RESOLVING DISPUTES:
ALL DISPUTES BETWEEN YOU AND LG ARISING OUT OF OR RELATING IN ANY WAY TO THIS LIMITED
WARRANTY OR THE PRODUCT SHALL BE RESOLVED EXCLUSIVELY THROUGH BINDING ARBITRATION, AND
NOT IN A COURT OF GENERAL JURISDICTION. BINDING ARBITRATION MEANS THAT YOU AND LG ARE EACH
WAIVING THE RIGHT TO A JURY TRIAL AND TO BRING OR PARTICIPATE IN A CLASS ACTION.
Definitions. For the purposes of this section, references to "LG" mean LG Electronics U.S.A., Inc., its parents,
subsidiaries and affiliates, and each of their officers, directors, employees, agents, beneficiaries, predecessors
in interest, successors, assigns and suppliers; references to "dispute" or "claim" shall include any dispute, claim
or controversy of any kind whatsoever (whether based in contract, tort, statute, regulation, ordinance, fraud,
misrepresentation or any other legal or equitable theory) arising out of or relating in any way to the sale, condition or
performance of the product or this Limited Warranty.
Cause
Aluminum foil or metal utensil used in
microwave mode
1. House power turned off (power supply)
2. Tripped breaker
3. The power cord is not installed properly
1. Improper blower unit direction or installation
2. Improper ductwork or damper connection
Exhaust Adapter
Slide exhaust
adapter into
guides on
rear panel.
DO NOT use aluminum foil or
metal utensils in microwave mode
1. Check house power supply
2. Check proper power cord
3. Check extension cord
1. Check blower unit direction and
2. Properly align the exhaust
Damper
(hinge side up)
3. Blower unit exhaust ports
4. After installation, check the air
Locking
Tabs
Guides
Solution
- Check user instructions
connection
reinstall if necessary.
ports and blower plate opening.
should be completely exposed
to the outside
ventilation path