Kenmore 146.20164510 Use & Care Manual page 21

Grill Head to Cart
□ This step requires two people to lift and position grill head onto cart.
□ Remove the tie wraps securing regulator hose to underside of grill head. Pull hose and igniter
wires out to side of grill head.
□ Carefully lower the grill head onto the cart. Make sure the regulator hose and igniter wires
are hanging outside the cart. Open lid and attach head to cart with (4) M6x13 screws and
M6 compression washers.
□ Slide grease accumulate panel into bottom of firebox from back. Make sure the grease
drainage hole is on the right side, as seen from the back of the grill.
□ Align back rail holes with holes on side panels and firebox. Attach back rail with (4) M4x10
screws.
M6X13 screw Qty: 4 pcs M6 compression washer Qty: 4 pcs M4X10 screw Qty: 4 pcs
23678-41100309 • 21