Related Manuals for Pico Macom DSP806
Summary of Contents for Pico Macom DSP806
- Page 1 DSP806 806MHz Agile PLL SAW-Filtered Digital-Analog Channel Processor Installation and Operation Manual Operation www.picomacom.com Ph:800-421-6511 Manual Rev. 01/03...
-
Page 2: Product Inspection
To insure proper installation and operation, take a moment to read this guide before proceeding with the installation. If you have any questions or comments about the DSP806 digital signal processor, please contact your dealer or have him contact the PICO MACOM Service Center at these phone numbers: 800-421-6511, 818-493-4300. - Page 3 21. Outdoor Antenna Grounding - Before attempting to install this product, be sure the antenna or cable system is grounded so as to DSP806 provide some protection against voltage surges and built-up static charges.
- Page 4 CMTS systems. The Surface Acoustic Wave (SAW) IF filtering provides highly selective frequency cut off at band edges for superior adjacent channel performance even in the most crowded systems. The DSP806 unique broad input AGC design delivers consistently high quality picture even at extremely low input levels. The microprocessor’s non-volatile memory preserves input and output channel identification...
-
Page 5: Specifications
806MHz Agile PLL SAW-Filtered Digital-Analog Channel Processor DSP806 806MHz Agile PLL SAW-Filtered Digital / Analog Processor POWER ® RF OUT RF Input Input Frequency Range: 54 - 806 MHz CATV Channels 2-125 UHF Channels 2-69 AGC Range: -15 dBmV to +35 dBmV input... -
Page 6: Operation And Controls
Operation and Controls DSP806 DSP806 806MHz Agile PLL SAW-Filtered Digital / Analog Processor POWER ® RF OUT Front and Rear Panels 1. Power on LED: Indicates power is on when lit. 2. Aural Carrier: Adjust audio/video ratio, when in analog mode only, with this control. -
Page 7: Installation Procedure
1. Connect the I.F. jumper from the I.F. output to the I.F. input on the rear panel. 2. Connect the DSP806 to a 115 VAC grounded receptacle. Observe the lit LED light indicating power is on. 3. Connect the antenna input signal and check the level at the input test point using a signal level meter or spectrum analyzer. The level must be at 0 dBmV minimum for a minimum carrier to noise ratio of 45 dB. -
Page 8: Limited Warranty
We will issue an invoice for the List Price of the loaner unit plus shipping costs. When you receive the loaner unit, pack the failed unit in the loaner unit’s box and ship it freight prepaid to Pico Macom for repair. When you receive the repaired unit, a new RMA number will be provided in the box. Carefully pack the loaner unit and affix the new RMA number on the box and ship it back to us for full credit excluding shipping costs.