INSTALLATION
16
4 Connecting Vent Hose
Align the tabs on the diffuser end of the vent hose to the slots in the panel assembly opening. Insert the diffuser and push it in
the Lock direction to assemble with the mounting plate.
• If disconnected, reconnect the other end of the vent hose to the product by inserting the vent hose into the product with
the mounting ring facing out. If the hose doesn't snap into place, rotate it slightly so the 2 lines at the front align.
5 Positioning Vent Hose
For best results, keep the vent hose as short and straight as possible. However, shape the diffuser end of the vent hose into
an inverted U shape just inside the window to allow any rain or condensation to drain out the window.
<Best positioning>
Window gap insulation
Mounting ring
<inverted U shape>
(2) UnLock
(1) Insert
Minimum
40 cm
<Correct Installation Position>