Replace The Dome Cover - Axis P5522-E Installation Manual

AXIS P5522–E PTZ Dome Network Camera
1
Protective packaging
3. If replacing the clear/smoked dome cover or installing an SD card, see page 15 and
page 16.
4. Put the top cover back in its original position and fasten the screws.

Replace the Dome Cover

Important
This product has a dehumidifying membrane to maintain low humidity levels inside the
dome. To avoid condensation, do not disassemble the camera in rain or in damp conditions.
Note
Be careful not to scratch or damage the dome cover. If possible, keep the protective plastic
on the dome cover until the installation is complete.
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
See Hardware Overview on page 10 for location of components.
1. Loosen the top cover screws and remove the top cover.
2. Remove the dome ring screws and remove the dome ring from the top cover.
3. Attach the dome ring and the replacement dome cover to the top cover and secure by
tightening the screws (torque 1.0 to 1.2 Nm).
4. To install an SD card (not included), see page 16.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
1
15