Bosch HII8057U User Manual page 44

en-us Troubleshooting
Fault
"E" and a number appears in dis-
play and control beeps
With a new oven there is a strong
odor when oven is turned on
Control does not react when a key
is touched
Warm air or steam escapes from
oven vent
Cooling fan runs even when the
oven is turned off
11.2 Cooktop troubleshooting
Fault
None
All displays flash
is flashing in the cooking zone
displays.
/
44
Cause and troubleshooting
An electronics fault has occured
Press any button or turn any knob to stop the beeping.
1.
Reset the oven if necessary.
2.
Call an authorized service provider.
3.
This is normal with a new oven and will disappear after a few uses
Operate the self clean mode to burn-off the smell more quickly.
▶
The control is wet or soiled
Clean the control panel an wipe it dry.
▶
The touch keys are not pressed correctly
Press the center of the button.
1.
Use the flat part of your finger.
2.
It is normal to see or feel steam or warm air escaping from the oven vent
CAUTION
The oven vents are important for air circulation. Covering the oven vents will cause
the oven to overheat. Refer to the appliance overview for the location of the oven
vents. → Page 12
▶ Do not obstruct oven vents.
The cooling fan will continue to run, even after the oven has been turned off, until
the oven has cooled sufficiently
This is normal. There is no action required.
▶
Cause and troubleshooting
The power supply has been disconnected.
Check whether the lighting in your kitchen or other appliances in the room are
▶
working.
The appliance has not been connected as shown in the circuit diagram.
Disconnect the appliance from the power supply.
1.
Make sure the appliance has been connected as shown in the circuit diagram.
2.
There is an electronics fault
If the fault cannot be eliminated, call Customer Service.
▶
Controls are wet or objects are lying on top of them.
Dry the controls or remove the object.
▶
There is an electronics fault
Briefly cover the control panel with your hand to acknowledge the fault.
▶
The electronics have overheated. The corresponding cooking zone has been
switched off.
Wait until the electronics have cooled down sufficiently.
1.
Touch any control element.
2.
a When error message disappears, the electronics have cooled down sufficiently.
You can continue to cook.
The electronics have overheated. The corresponding cooking zone has switched
off.
Wait until the electronics have cooled down sufficiently.
1.
Touch any control element.
2.
a When error message disappears, the electronics have cooled down sufficiently.
You can continue to cook.
The electronics have overheated. All cooking zones have switched off.
Wait until the electronics have cooled down sufficiently.
1.
Touch any control element.
2.
a When error message disappears, the electronics have cooled down sufficiently.
You can continue to cook.