Front Of The Cpe; Back Of The Cpe - Motorola CPEi 725 User Manual

1

Front of the CPE

Back of the CPE

1-2
The front of the CPE unit contains LED Link/Activity indicators. The LEDs provide the
status of the unit and signal strength indicators for easy adjustment during setup.
Table 1-1 LED Indicator Interface
LED
Signal Strength
WAN WiMAX
CAUTION
If all five WiMAX Signal Strength LEDs are blinking, then a software up-
grade is in progress. Do NOT remove power to the CPE.
The back of the CPE unit contains the reset switch, AC Power Connector, Ethernet
connector, Ethernet LED
Status
Full WiMAX Signal Strength is detected
when all WiMAX Signal Strength LEDs are
lit.
• All WiMAX Signal Strength LEDs are
• One to two WiMAX Signal Strength
• Three to five WiMAX Signal Strength
While acquiring access to the WiMAX
Network:
• All WiMAX Signal Strength LEDs vary
and port
telephone .
Desktop CPEi 725 User Guide
off - very low signal detected.
LEDs are lit - low signal detected.
LEDs are lit - high signal detected.
between ON, OFF and/or BLINKING
status.