Fujitsu AG G09LVCA Series Design & Technical Manual page 27
Floor type
Hide thumbs
Also See for AG G09LVCA Series:
- Service instruction (122 pages) ,
- Service instruction (77 pages) ,
- Service instruction (69 pages)
Table of Contents
Advertisement
4) Room temperature control for heating
Depending on the installed environment, correction of the room temperature sensor may be
required.
Select the appropriate control setting according to the installed environment.
Setting Description
Standard
Lower control
Slightly higher control
Higher control
5) Auto restart
Enable or disable automatic restart after a power interruption.
Setting Description
Enable
Disable
* Auto restart is an emergency function such as for power outage etc. Do not attempt to use this
function in normal operation.
Be sure to operate the unit by remote controller or other external input device.
6) Room temperature sensor switching
(Only for wired remote controller)
When using the Wired remote controller temperture sensor, change the setting to "Both" (01).
Setting Description
Indoor unit
Both
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller is active.
7) Remote controller signal code
(Only for wireless remote controller)
The indoor unit signal code can be changed. Select the appropriate signal code.
Setting Description
A
B
C
D
( . . .Factory setting)
Function Number
Setting Value
31
( . . .Factory setting)
Function Number
Setting Value
40
( . . .Factory setting)
Function Number
Setting Value
42
( . . .Factory setting)
Function Number
Setting Value
44
- (01 - 24) -
00
01
02
03
00
01
00
01
00
01
02
03
Advertisement
Table of Contents
