First Startup Configuration - Navico Lowrance Link-6S User Manual

5. NMEA 0183® TX_A (white): connect to RX_A of chart plotter
6. NMEA 0183® TX_B (brown): connect to RX_B of chart plotter
4.
Antenna: connect to a marine VHF antenna using 50 ohm cable
fitted with a PL-259 connector
5.
GND: optional ground connection. May help with induced noise
issues
6.
Optional External GPS Antenna connection (SMA).
¼ Note:
External speaker and plotter connections are optional.

First startup configuration

The first time the radio is powered up, the user is prompted to make
a series of setting selections in order to allow the radio to perform
to its full potential. Some steps must be completed; some are
optional and can be completed later. The steps are outlined below
for reference:
Select the region and country the radio will be operated in.
Enter MMSI number if known, or skip to next step. Re-enter number
to confirm correct entry.
¼ Note:
MMSI entry can only be done once. Changing the MMSI
requires radio be returned to a Lowrance dealer.
For some EU region radios only: Enter the ATIS ID number. Re-enter
Installation | Link-6S User Guide
| 39