Table of Contents
Advertisement
6. Install the new storage drive into the storage drive bay.
7. Screw the storage drive back into the storage drive bay.
8. Connect the signal cable and the power cable to the storage drive.
9. Reinstall all removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
Note: If a locking device is available, use it to lock the computer.
Storage drive bay
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Replacement procedure
1. Remove the power cord. See "Power cord" on page 53.
2. Remove the computer cover. See "Computer cover" on page 54.
3. Remove the front bezel. See "Front bezel" on page 56.
4. Disconnect the signal cable and the power cable from the storage drive.
Notes: The storage drive will vary depending on your model:
• If your model has a 3.5-inch storage drive, follow step
• If your model has a 2.5-inch storage drive, follow step
1
on the illustration.
2
on the illustration.
.
Chapter 6
Hardware removal and installation
61
Advertisement
Table of Contents
