Remove The Lcd Module - Lenovo ThinkBook 14 G4 IAP Hardware Maintenance Manual

Remove the LCD module

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 34
"Remove the heat sink" on page 40
"Remove the fan" on page 41
Step 1. Peel off the mylar carefully.
Note: The mylar is not reusable. Replace it when replacing related FRUs.
Figure 37. Peel off the mylar
Step 2. Detach the antenna cable connectors and then disconnect the EDP cable from the system board.
Figure 38. Detach the antenna cable connectors and disconnect the EDP cable
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove five screws and then remove the LCD module.
.
Chapter 4 Removing a FRU or CRU
53