GE 22 Owner's Manual & Installation Instructions page 20

REVERSING THE DOOR SWING
TRANSFER CENTER HINGE
5
BRACKET TO THE LEFT
Remove the center hinge bracket by removing
the three screws.
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
You will need to remove the color-matched cap from
the screw head before you can remove the screw.
Use the edge of a thin flat blade to gently pry the
caps off the screw heads. (A putty knife works well
for this.) Cover the blade with tape to prevent
scratching the paint.
Remove the mullion cover from the left side using
the thin flat blade. Assemble it to the right side.
Remove the screw from the center left side of the
cabinet. Screw it into the holes on the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Replace the cap by snapping it over the screw with
your finger.
Mullion Cover
TRANSFER DOOR STOPS
6
On each door, move the metal door stop from the
right to the left.
Move any screws from the left to the right.
All manuals and user guides at all-guides.com
Installation Instructions
Screw Cap
20
(CONT.)
TRANSFER REFRIGERATOR
7
DOOR HANDLE TO THE RIGHT
To remove the handle: Remove the plug button by
carefully prying under the edge with a putty knife.
Remove the exposed screw holding the handle.
Handle Plug
Remove the two screws holding the handle to the
top of the door.
Long Handle
Short
Screw
Hole
Pin
After removing the handle: Move the small plug
buttons from the top right side of the door top and
insert them into the holes on the opposite side.
Move the large plug button from the left edge of the
door and insert it into the hole on the opposite side.
Plug Button
Short Handle
Handle
Plug
Small Plug
Buttons
Handle
Plug